SHIFT6m - Replacing the back cover

The backcover of the SHIFT6m is not glued or screwed and can be removed without tools.

However, you can also use a plectrum to loosen the clips along the entire edge.

1. Use a plectrum or a fingernail to slide it into the small recess in the bottom left corner and pull up the backcover.
2. Then gradually loosen all clips all around. The back cover is hooked again around the fingerprint sensor. There you have to pull a little harder to loosen the backcover.

Put the back cover back on.

1. The back cover has clips on the edge and around the opening of the fingerprint sensor.
2. Press the backcover everywhere until it fits properly.