Samsung Galaxy S10e - Replace the speaker

Replace the speaker of your Galaxy S10e yourself

  • Galaxy S10e
  • 10 Steps
  • Medium
  • 60 min.
Go to the guide

Introduction

Is the sound of your Galaxy S10e very low when playing music or watching videos, or do you have rattling or cracking noises? With this guide, you can replace the Galaxy S10e's speaker yourself.

Required tools

  • Flache Plektren

    Flache Plektren

    You need a very flat tool such as a flat pick to pry out parts that are glued in place.

    €1.00 at the iDoc store
  • Heat gun

    Heat gun

    You can use a heat gun to heat parts that are glued on so they’re easier to remove. In most cases, you can also use a hairdryer.

    from €14.99 on Amazon
  • iFlex opening tool

    iFlex opening tool

    Die kleinen Teile in deinem Smartphone auseinanderzukriegen kann eine sehr große Arbeit bedeuten. Die Klinge des kompakten aber stabilen iFlex hat eine Dicke von nur 0,15 mm, sodass es auch in den kleinsten Spalten reinpasst, beispielsweise zwischen dem Display und dem Rahmen oder unter dem Logicboard. Das praktische iFlex ist aus hochwertigem rostfreiem Stahl und liegt gut in der Hand. Damit ist es der perfekte Helfer bei jeder Smartphone-Reparatur.

    €9.00 at the iDoc store
  • iPlastix

    iPlastix

    Dein Smartphone zu öffnen kann eine sehr empfindliche Angelegenheit sein. Die Klinge des biegsamen aber stabilen iPlastix hat eine Dicke von nur 0,15 mm, sodass es auch in den kleinsten Spalten reinpasst, beispielsweise zwischen dem Display und dem Rahmen oder unter dem Logicboard. Das praktische iPlastix ist aus biegsamem Kunststoff und liegt gut in der Hand. Damit ist es der perfekte Helfer bei jeder Smartphone-Reparatur.

    €9.00 at the iDoc store
  • Tweezers

    Tweezers

    We recommend using tweezers to remove screws and various small parts from your device.

    €16.00 at the iDoc store
  • Phillips PH00 screwdriver

    Phillips PH00 screwdriver

    You need the right screwdriver for removing PH00 screws.

    €10.00 at the iDoc store

Required replacement part

  • Samsung Galaxy S10e Lautsprecher

    Samsung Galaxy S10e Lautsprecher

    Audio-Probleme beim Samsung Galaxy S10e? Dieses Original Ersatzteil wird dir helfen! Wenn du eingehende Anrufe nicht mehr mitbekommst, keine Whats App Audiomessages mehr abhören kannst oder du andere Probleme mit dem Lautsprecher deines Samsung Smartphones hast, dann wird dir der neue Lautsprecher den klaren Sound zurückbringen, den du so liebst. Worauf wartest du? Tasuche jetzt deinen defekten Lautsprecher gegen einen funktionierenden und erfreue dich am neuen Klangerlebnis.

    €18.00 at the iDoc store
Show all replacement parts for the Galaxy S10e 

Replacement parts and tools for this repair

Our tools plus the right spare part help you fix your device easily.

Samsung Galaxy S10e Lautsprecher

Audio-Probleme beim Samsung Galaxy S10e? Dieses Original Ersatzteil wird dir helfen! Wenn du eingehende Anrufe nicht mehr...

Werkzeugset Samsung

Ganz gleich, welches Problem dein Handy hat - mit unserem Werkzeugset kannst du es bestimmt beheben. Dieses Reparaturset umfasst jeweils einen...

together for €67.00

Getting started

If you get stuck or have questions, you can post a comment for each step. We’d be happy to help.

10 steps
  1. Switching off your device

    Galaxy S10e - Switching off your device 01
    Galaxy S10e - Switching off your device 02
    1. Turn off your device by holding down the power button until the “Power off” option appears.
    2. Use your finger to confirm that you want to shut down your device and wait until the screen goes blank.

    Klick the small Play button in the top right of an image to play a video for each step.

  2. Removing the back cover

    Galaxy S10e - Removing the back cover 01
    Galaxy S10e - Removing the back cover 02
    Galaxy S10e - Removing the back cover 03
    Galaxy S10e - Removing the back cover 04
    Galaxy S10e - Removing the back cover 05
    Galaxy S10e - Removing the back cover 06
    Galaxy S10e - Removing the back cover 07
    Galaxy S10e - Removing the back cover 08
    1. The back cover’s heavily glued to the chassis. Heat the device evenly with hot air to soften the glue. A temperature of 60 - 80°C should be sufficient. As a rule of thumb, you should still be able to touch your device without it being uncomfortably hot.
    2. The easiest way to loosen the back cover is to use a flat and flexible tool such as the iPlastix or iFlex. You will also need several picks to unstick the back cover all around.
    3. Heat the spot where you start and place a flat tool between the back cover and the frame.

    The iPlastix is made of plastic, so it won't scratch the device. On the other hand, it's very soft and tricky to insert. The iFlex makes it easier to get into the gap between the glass and the frame because it's made of very thin, stable metal. But it also makes it easier to scratch the frame of your S10e. To get into the gap initially, you can use the iFlex and then continue with the iPlastix as soon as possible.

    Be extra careful, the back cover can break very easily. If necessary, apply the heat several times and try again. Removing the back cover might take half an hour. Take a little more time and work carefully to make sure you don't break anything.

    1. Once the tool is inserted, stick a pick into the gap to keep it open. Then run the tool around the entire edge to gradually loosen the glue.
    2. Then heat the next part and insert the picks one by one.
    Use a suction cup to lift the glass if you can’t find anywhere to insert the tool.
  3. Removing the plastic cover

    Galaxy S10e - Removing the plastic cover 01
    Galaxy S10e - Removing the plastic cover 02
    Galaxy S10e - Removing the plastic cover 03
    • 8 × 3,9 mm Phillips
    1. Loosen the Phillips screws that secure the cover. The contactless charging coil and NFC antenna are attached to the plastic cover.
    2. The cover is hooked into the top of the housing and the lower part is lightly glued on. Carefully slide a flat tool under the attached areas and loosen them.
    3. Now you can remove the cover together with the coil.
  4. Disconnecting the battery

    Galaxy S10e - Disconnecting the battery 01
    Galaxy S10e - Disconnecting the battery 02
    • Battery Connector
    1. Using the spudger, carefully disconnect the battery contact from the motherboard.

    Always lever from a side where there are no small components on the motherboard. This avoids unintentional damage to capacitors or ICs.

  5. Removing the speaker

    Galaxy S10e - Removing the speaker  01
    Galaxy S10e - Removing the speaker  02
    Galaxy S10e - Removing the speaker  03
    • 7 × 3,9 mm Phillips
    1. Loosen the Phillips screws that secure the speaker and then remove it.
    2. You can loosen the speaker more easily by lifting it up a little at the openings at the side. The openings are marked with small triangular arrows.
  6. Installing the speaker

    Galaxy S10e - Installing the speaker 01
    Galaxy S10e - Installing the speaker 02
    Galaxy S10e - Installing the speaker 03
    • 7 × 3,9 mm Phillips
    1. Then place the speaker back over the USB port, press it in and screw it tight.
    2. Make sure it's latched in at the bottom.
  7. Connecting the battery

    Galaxy S10e - Connecting the battery 01
    Galaxy S10e - Connecting the battery 02
    • Battery Connector
    1. Connect the battery to the motherboard. Press the contact onto the connection on the motherboard until you hear it click into place.
  8. Installing the plastic cover

    Galaxy S10e - Installing the plastic cover 01
    Galaxy S10e - Installing the plastic cover 02
    Galaxy S10e - Installing the plastic cover 03
    • 8 × 3,9 mm Phillips
    1. Put the cover with the antenna back in the enclosure after hooking it onto the top of the enclosure.
    2. Then press the cover with your fingers until it clicks gently into place.
    3. Fasten the phillips screws.
  9. Testing the device

    Galaxy S10e - Testing the device 01
    Galaxy S10e - Testing the device 02
    Galaxy S10e - Testing the device 03
    1. Turn on your device and test it with the integrated test mode.
    2. Access the test mode by dialing *#0*#
    3. Follow the instructions and test the screen, the cameras and the sensors

    Test especially all functions of the part you replaced.

  10. Attaching the back cover

    Galaxy S10e - Attaching the back cover 01
    Galaxy S10e - Attaching the back cover 02
    Galaxy S10e - Attaching the back cover 03

    If the adhesive on the back cover is still intact, you can seal your device without using a new adhesive frame.

    1. Put the back cover back in its original position.
    2. Press the back cover on all over so the glue will stick.

    You can also heat your device with hot air and then clamp it or weight it down with a couple books so the glue will stick better.

    If you install a new backcover, now remove the last protective films from the adhesive surfaces.
Ø 0 (0 Bewertungen)

Bewerte unsere Anleitung

Hat dir unsere Anleitung weitergeholfen? Wir sind auf deine Beurteilung gespannt.

Bewertung abgeben

Bewertung abgeben

Wie findest du unsere Reparatur-Anleitung Galaxy S10e Replace the speaker?

Exzellent

Similar guides

You might also be interested in these guides.

You might be interested in

Get in touch with iDoc

Please contact our customer service for any questions about iDoc's products and services.

  • Send a message

    If you have a question about a guide or want to give us general feedback, just use our contact form

    Write a message
  • Free shipping

    From a minimum order value of 39.00 € your order will be shipped free of charge within Germany.

  • Call iDoc

    If you have any questions about our guides or services, call us from Monday to Friday, 10:00 a.m. to 6:00 p.m.

    +49 30 200 514 455
  • 5 star service

    We offer top quality and service. Our customers confirm this as well.

    Show reviews