Samsung Galaxy S9 - Replace earpiece

Can't hear when you make a call?

  • Galaxy S9
  • 21 Steps
  • Difficult
  • 45 min.
Go to the guide

Introduction

This guide shows you how to replace the defective earpiece of your Samsung Galaxy S9.

This repair helps, if you can't hear anything on the phone or your sound quality is worse than normal.

Click the small Play button in the top right of an image to play a video for each step.

Required tools

  • Flache Plektren

    Flache Plektren

    You need a very flat tool such as a flat pick to pry out parts that are glued in place.

    €1.00 at the iDoc store
  • Heat gun

    Heat gun

    You can use a heat gun to heat parts that are glued on so they’re easier to remove. In most cases, you can also use a hairdryer.

    from €14.99 on Amazon
  • For storing screws

    For storing screws

    We recommend storing your screws so you don’t mix up the various screws and small parts.

    €10.00 at the iDoc store
  • iFlex opening tool

    iFlex opening tool

    Die kleinen Teile in deinem Smartphone auseinanderzukriegen kann eine sehr große Arbeit bedeuten. Die Klinge des kompakten aber stabilen iFlex hat eine Dicke von nur 0,15 mm, sodass es auch in den kleinsten Spalten reinpasst, beispielsweise zwischen dem Display und dem Rahmen oder unter dem Logicboard. Das praktische iFlex ist aus hochwertigem rostfreiem Stahl und liegt gut in der Hand. Damit ist es der perfekte Helfer bei jeder Smartphone-Reparatur.

    €9.00 at the iDoc store
  • iPlastix

    iPlastix

    Dein Smartphone zu öffnen kann eine sehr empfindliche Angelegenheit sein. Die Klinge des biegsamen aber stabilen iPlastix hat eine Dicke von nur 0,15 mm, sodass es auch in den kleinsten Spalten reinpasst, beispielsweise zwischen dem Display und dem Rahmen oder unter dem Logicboard. Das praktische iPlastix ist aus biegsamem Kunststoff und liegt gut in der Hand. Damit ist es der perfekte Helfer bei jeder Smartphone-Reparatur.

    €9.00 at the iDoc store
  • Tweezers

    Tweezers

    We recommend using tweezers to remove screws and various small parts from your device.

    €16.00 at the iDoc store
  • Plastic prying tool

    Plastic prying tool

    You need a flat plastic prying tool to disconnect the various plugs and connectors.

    €1.00 at the iDoc store
  • Suction cup

    Suction cup

    A suction cup is perfect for lifting smooth surfaces such as displays or rear glass panels.

    €2.00 at the iDoc store
  • Phillips PH00 screwdriver

    Phillips PH00 screwdriver

    You need the right screwdriver for removing PH00 screws.

    €10.00 at the iDoc store

Required replacement part

  • Samsung Galaxy S9 Hörmuschel

    Samsung Galaxy S9 Hörmuschel

    Ein Smartphone ist zum Telefonieren da – Das gilt auch für dein Samsung Galaxy S9. Doch dann das: Der Klang deines Gegenübers ist total verzerrt oder hat einfach eine schlechte Qualität. Du hörst deinen Gesprächspartner kaum noch. Dir kommt das bekannt vor? Dann kann es an deiner Hörmuschel liegen. Bei uns erhältst du das passende Original Ersatzteil, um den Klang deines Samsung S9 wieder zu verbessern.

    €14.00 at the iDoc store
Show all replacement parts for the Galaxy S9 

Replacement parts and tools for this repair

Our tools plus the right spare part help you fix your device easily.

Samsung Galaxy S9 Hörmuschel

Ein Smartphone ist zum Telefonieren da – Das gilt auch für dein Samsung Galaxy S9. Doch dann das: Der Klang deines Gegenübers...

Werkzeugset Samsung

Ganz gleich, welches Problem dein Handy hat - mit unserem Werkzeugset kannst du es bestimmt beheben. Dieses Reparaturset umfasst jeweils einen...

together for €63.00

Getting started

If you get stuck or have questions, you can post a comment for each step. We’d be happy to help.

21 steps
  1. Switching off your device

    Galaxy S9 - Switching off your device 01
    Galaxy S9 - Switching off your device 02
    Galaxy S9 - Switching off your device 03
    1. Turn off your device by holding down the power button until the “Power off” option appears.
    2. Use your finger to confirm that you want to shut down your device and wait until the screen goes blank.

    Klick the small Play button in the top right of an image to play a video for each step.

  2. Remove back cover

    Galaxy S9 - Remove back cover 01
    Galaxy S9 - Remove back cover 02
    Galaxy S9 - Remove back cover 03
    Galaxy S9 - Remove back cover 04
    Galaxy S9 - Remove back cover 05

    To loosen the back cover, use a heat gun or an ordinary hair dryer. Warm glue is easier to loosen, allowing you to remove the back cover. The easiest way to loosen the back cover is to use a flat and flexible tool such as the iPlastix or iFlex.

    You will also need several picks to unstick the back cover all around.

    1. Heat the spot where you start and place a suction cup on the bottom of the back cover.
    2. Press a flat tool between the back cover and the frame and pull on the suction cup.

    The iPlastix is made of plastic, so it won't scratch the device. On the other hand, it's very soft and tricky to insert.

    Be extra careful, the back cover can break very easily. If necessary, apply the heat several times and try again. Removing the back cover might take half an hour. Take a little more time and work carefully to make sure you don't break anything.

    1. Once the tool is inserted, stick a pick into the gap to keep it open. Then run the tool around the entire edge to gradually loosen the glue.
    2. Then heat the next part and insert the picks one by one.

    The back cover glue is extra strong on the lower edge.

    1. Once the back cover is loosened, lift it very slightly. The fingerprint sensor underneath the camera is still connected with a cable.
  3. Disconnect fingerprint sensor

    Galaxy S9 - Disconnect fingerprint sensor 01
    Galaxy S9 - Disconnect fingerprint sensor 02
    Galaxy S9 - Disconnect fingerprint sensor 03
    1. After detaching the back cover, carefully lift it and disconnect the fingerprint sensor using the spudger.
    2. Then you can completely remove the back cover and set it aside.
  4. Remove midframe

    Galaxy S9 - Remove midframe 01
    Galaxy S9 - Remove midframe 02
    Galaxy S9 - Remove midframe 03
    • 10 × 4.0 mm Phillips

    Then remove all the equally long Phillips screws from the logic board cover and store them together.

    This phone has only two different screw lengths. If some screws don't come off immediately, you can also use a pair of tweezers.

    1. The logic board cover with the NFC tag is latched in at the top.
    2. Pry it up a little and then take it out.
  5. Disconnect battery

    Galaxy S9 - Disconnect battery 01
    Galaxy S9 - Disconnect battery 02
    • Battery connector
    1. Now the battery connector is free.
    2. To avoid short circuits during the repair, disconnect the battery.
  6. Remove the speaker unit

    Galaxy S9 - Remove the speaker unit 01
    Galaxy S9 - Remove the speaker unit 02
    Galaxy S9 - Remove the speaker unit 03
    • 5 × 4.0 mm Phillips

    Now remove the speaker. These screws are also equally long.

    1. Lift the speaker a little using tweezers and then remove it.
  7. Remove front camera

    Galaxy S9 - Remove front camera 01
    Galaxy S9 - Remove front camera 02
    Galaxy S9 - Remove front camera 03
    Galaxy S9 - Remove front camera 04
    • Connector
    1. Now disconnect the front camera connector using a spudger.
    2. Pry it up from the free side where there are no PCB components.
    3. Then take the camera out of its holder.
  8. Remove SIM tray

    Galaxy S9 - Remove SIM tray 01
    Galaxy S9 - Remove SIM tray 02
    1. Now remove the SIM tray.
    2. The best way is to use a SIM tool or a paper clip.
    3. Then pull out the SIM tray.
  9. Unplug connectors

    Galaxy S9 - Unplug  connectors 01
    Galaxy S9 - Unplug  connectors 02
    Galaxy S9 - Unplug  connectors 03
    Galaxy S9 - Unplug  connectors 04
    Galaxy S9 - Unplug  connectors 05
    Galaxy S9 - Unplug  connectors 06
    • Connector
    • Antenna Plug
    1. Now disconnect the different plugs from the logic board.
    2. Twist the spudger gently. Don't use it like a crowbar, or you may damage the logic board.
    3. There are small parts next to the connectors that break easily.
    4. Then disconnect the button plugs of the antenna cables.
    5. Grab the cable with the tweezers, not on the plug itself.
    6. Disconnect the plug with a twist of the tweezers.

  10. Remove logic board

    Galaxy S9 - Remove logic board 01
    Galaxy S9 - Remove logic board 02
    Galaxy S9 - Remove logic board 03
    Galaxy S9 - Remove logic board 04
    • 1 × 3.4 mm Phillips
    1. Now remove the single screw on the logic board.
    2. Before removing the logic board, make sure that all connectors are bent aside and don't get stuck.
    3. The bottom side of the logic board is still connected to the USB board. Fold up the logic board and flick off the connector using a spudger.
    4. Then put the logic board aside.
    There's a small plastic pin in the opening of the SIM tray. Make sure it doesn't fall out.
  11. Insert earpiece

    Galaxy S9 - Insert earpiece 01
    Galaxy S9 - Insert earpiece 02
    Galaxy S9 - Insert earpiece 03
    1. The earpiece is glued to the enclosure. Using the steel spatula, carefully detach the earpiece from the glue.
    2. Remove the earpiece from the enclosure.
  12. Install earpiece

    Galaxy S9 - Install earpiece 01
    Galaxy S9 - Install earpiece 02
    1. Put the earpiece in the little recess in the upper edge of the enclosure.
    2. Press the earpiece on a little so the glue will stick.
  13. Insert mainboard

    Galaxy S9 - Insert mainboard 01
    Galaxy S9 - Insert mainboard 02
    Galaxy S9 - Insert mainboard 03
    Galaxy S9 - Insert mainboard 04
    • 1 × 3.4 mm Phillips
    1. Take the logic board and plug in the connector at the bottom.
    2. Now you slowly fold the logic board into the device.
    3. Make sure you don't squeeze in any cables.
    4. Bend all antennas and connectors to the side.
    5. Press the logic board in to make it click into place.
    6. Then fasten the single screw of the logic board.
  14. Attach connectors

    Galaxy S9 - Attach connectors 01
    Galaxy S9 - Attach connectors 02
    Galaxy S9 - Attach connectors 03
    • Connector
    • Antenna plug

    Now attach all the plugs.

    1. You can position the antenna plugs with tweezers and then click them on.
    2. Also attach the connectors for the display and the volume buttons.
    3. All connectors engage with a click. If not, remove the connector and try again.

  15. Insert SIM tray

    Galaxy S9 - Insert SIM tray 01
    1. Now insert the SIM tray.

    If it gets stuck, the logic board may not be sitting right.

  16. Insert front camera

    Galaxy S9 - Insert front camera 01
    Galaxy S9 - Insert front camera 02
    Galaxy S9 - Insert front camera 03
    • Connector
    1. Insert the front camera and attach its connector.
  17. Install speaker unit

    Galaxy S9 - Install speaker unit 01
    Galaxy S9 - Install speaker unit 02
    Galaxy S9 - Install speaker unit 03
    • 5 × 4.0 mm Phillips
    1. Then place the speaker back over the USB board, press it in and screw it tight.
    2. Make sure it's latched in at the bottom.
  18. Connect battery

    Galaxy S9 - Connect battery 01
    • Battery connector
    1. Connect the battery connector.
  19. Insert midframe

    Galaxy S9 - Insert midframe 01
    Galaxy S9 - Insert midframe 02
    Galaxy S9 - Insert midframe 03
    • 10 × 4.0 mm Phillips
    1. Then attach the midframe with the NFC tag.
    2. Latch it in and press it in all around.
    3. Then fasten all the screws again.
  20. Connect fingerprint sensor

    Galaxy S9 - Connect fingerprint sensor 01
    Galaxy S9 - Connect fingerprint sensor 02
    Galaxy S9 - Connect fingerprint sensor 03
    Galaxy S9 - Connect fingerprint sensor 04
    • Fingerprint connector
    1. Before attaching the back cover, plug in the fingerprint sensor connector.
    2. Use a plastic tool to reach the connector.
  21. Attach back cover

    Galaxy S9 - Attach back cover 01
    Galaxy S9 - Attach back cover 02
    1. Before reattaching the back cover, check the glue. It should be sitting evenly on the back cover. You can remove any excess glue.
    2. Then press on the back cover.
    3. Heat the back cover again to bond the glue.
    4. You can press on the back cover with your fingers while the glue cools down.

    Please note that your smartphone's water ingress protection is no longer the same after you open it.

Ø 0 (0 Bewertungen)

Bewerte unsere Anleitung

Hat dir unsere Anleitung weitergeholfen? Wir sind auf deine Beurteilung gespannt.

Bewertung abgeben

Bewertung abgeben

Wie findest du unsere Reparatur-Anleitung Galaxy S9 Replace earpiece?

Exzellent

Similar guides

You might also be interested in these guides.

You might be interested in

Get in touch with iDoc

Please contact our customer service for any questions about iDoc's products and services.

  • Send a message

    If you have a question about a guide or want to give us general feedback, just use our contact form

    Write a message
  • Free shipping

    From a minimum order value of 39.00 € your order will be shipped free of charge within Germany.

  • Call iDoc

    If you have any questions about our guides or services, call us from Monday to Friday, 10:00 a.m. to 6:00 p.m.

    +49 30 200 514 455
  • 5 star service

    We offer top quality and service. Our customers confirm this as well.

    Show reviews