Removing the speaker and taptic engine bracket plate

• 1 × 1,9 mm Phillips
• 1 × 1,4 mm Phillips
• 2 × 1,6 mm Phillips
• 3 × 1,2 mm Phillips
• Connector

1. Remove the Phillips screws of different lengths from the cover plate of the speaker and the Taptic Engine. Place the screws on your magnet mat so that you can reassign them correctly later.

There is a short flex cable attached to the cover, which is connected to a contact underneath.

1. Fold the cover plate to the side and separate the small square connector with a spudger.
2. Finally, remove the cover plate.